GALVA range

90° T-piece: TE 90°

The TE 90° T-piece is used to connect two ductwork branches at an angle of 90°.

45° branch piece: TO 45°

The TE 45° T-piece is used to connect two ductwork branches at an angle of 45°.

Male - Female Plug: BMF

The Male - Female Plug seals off a galvanised steel duct or accessory in commercial and multi-occupancy residential buildings.

T-piece branch connector: CP

The T-piece branch connector creates a junction and access point for the vertical collector system and the horizontal ducting.

T-piece branch connector for air tightness readings: CPT

The CPT T-piece branch connector for air tightness readings creates a junction and access point for the vertical collector system and the horizontal ducting.

Storey manifold (CRE): Multi-dwelling CRE

The multi-dwelling CRE storey manifold can connect two dwellings on the same storey to the same vertical riser.

Storey manifold (CRE): Standard CRE storey collector

The CRE standard storey manifold is used to connect up to four 125 mm diameter ducts to the vertical riser.

90° Y-branch piece: CS 90°

The 90° Y-piece enables confluence of 2 galvanised duct branches at 90° from each other.

30° bend

The 30° bend is used to change the direction of a galvanised ducting system by a 30° angle.

45° bend

The 45° bend is used to change the direction of a galvanised ducting system by a 45° angle.

90° bend

The 90° bend is used to change the direction of a galvanised ducting system by a 90° angle.

Circular 90° Branch Connector: PEC 90°

The PEC circular 90° branch connector makes a right-angle branch on a galvanised circular duct.

Flat 90° Branch Connector: PEP 90°

The PEP flat 90° branch connector makes a right-angle branch on a galvanised oblong or rectangular duct.

Circular Oblique Branch Connector: POC 45°

The PEC circular branch connector makes a 45° angle branch on a galvanised circular duct.

Flat Oblique Branch Connector: POP 45°

The POP angled branch connector makes a 45° angle branch on a galvanised oblong or rectangular duct.

Female connector: RF

The female connector connects two galvanised accessories together.

Male connector: RM

The male connector connects two galvanised ducts together.

Concentric Conical Reducer: RCC

The RCC joins two galvanised ducts of different diameters together.

Concentric Flat Reducer: RPC

The RPC joins two galvanised ducts of different diameters together over a minimum length.

Acoustic and Aeraulic T-piece branch connector: CP2A

The CP2A branch connector provides a junction and accessibility to the vertical collector system and horizontal ducting, improves acoustic and aeraulic performance.

Acoustic and aeraulic T-piece branch connector for airtightness readings:CPT2A;galvanised acoustic and aeraulic T-piece branch connector for airtig...

The CPT2A branch connector provides a junction and accessibility to the vertical collector system and horizontal ducting, improves acoustic and aeraulic performance.

Circular Protective Screen: GPC

The GPC circular protective screen is an anti-bird screen for attachment to circular ducts.

Flat roof penetration sleeve: FT.

The flat roof penetration sleeve is a ducting accessory used to protect the duct as it passes through the flat roof.

Sealing flap

The sealing flap is a galvanised steel ducting accessory that ensures a leaktight seal on roof penetrations.

60° bend