Aluminium 45° bend
Airflow control
Aluminium 45° bend
Airflow control
The aluminium 45° bend is used to change the direction of an aluminium ducting system by a 45° angle.
Aluminium 45° bend
The aluminium 45° bend is used to change the direction of an aluminium ducting system by a 45° angle. Bends up to diameter 500 are sector bends.
The + products
- range compliant with gas CMEV requirements,
- suited to systems operating in saline atmospheres.
- available in diameters from 125 to 500,
- aluminium 1050A-H18 (formerly A5) compliant with DTU 68.3 for gas CMEV,
- M0 fire certification.
- easy assembly of interlocking accessories: ducts are female, accessories are male,
- Final seal requires sealant and/or perforated strip,
- attached to duct using self-tapping screws (4 to 6 depending on diameter).
| Main material | Insulation material |
|---|---|
| Aluminium |
| References | Ø (mm) | Ø A (mm) |
|---|---|---|
| 11095343 - C 45° BEND aluminium - D125 | 125 |
125 |
| 11095345 - C 45° BEND aluminium - D160 | 160 |
160 |
| 11095346 - C 45° BEND aluminium - D200 | 200 |
200 |
| 11095347 - C 45° BEND aluminium - D250 | 250 |
250 |
| 11095348 - C 45° BEND aluminium - D315 | 315 |
315 |
| 11095349 - C 45° BEND aluminium - D355 | 355 |
355 |
| 11095350 - C 45° BEND aluminium - D400 | 400 |
400 |
| 11095351 - C 45° BEND aluminium - D450 | 450 |
450 |
| 11095352 - C 45° BEND aluminium - D500 | 500 |
500 |
| Fire protection rating |
|---|
| M0 |
