RPM shut-off damper
Wipe
RPM shut-off damper
Wipe
The RPM will shut off a system branch as soon as it receives a command signal to do to.
RPM shut-off damper
The RPM is a motorised plastic damper. If triggered by a timer switch, a clock or a BMS signal, a thermal actuator will close the flap to isolate a system branch.
The + products
- Motorised ducting isolation solution, very easy to install.
The RPM damper will use a thermal actuator to close its flap, to isolate the circuit. Caution, this damper must not be activated for more than 24 h continuously.
- Plastic body material, M1 fire certification,
- Operating pressure P < 200 Pa.
- installed directly between two circular ducts,
- installation direction indicated on the RPM,
- the RPM must not be activated for more than 24 hours continuously,
- for connection with e.g. time delay switch ref. 11022008.
| Insulation material |
|---|
| References | L (mm) | Ø (mm) | Weight (kg) |
|---|---|---|---|
| 11093017 - RPM Ø 125 - 230V | 145 |
125 |
0,628 |
| 11093018 - RPM Ø 125 - 12-24 V | 145 |
125 |
0,628 |
| 11016061 - RPM Ø 200 - 230 V | 210 |
200 |
1,2 |
| Pressure range (Pa) |
|---|
| < 200 |
| References | Voltage (V) | Frequency (Hz) | Protection current (A) | Power supply |
|---|---|---|---|---|
| 11093017 - RPM Ø 125 - 230V | 230 |
50/60 |
2 |
Single-phase |
| 11093018 - RPM Ø 125 - 12-24 V | 12/24 |
50/60 |
2 |
Single-phase |
| 11016061 - RPM Ø 200 - 230 V | 230 |
50/60 |
2 |
Single-phase |
| Fire protection rating |
|---|
| M1 |
