Aluminium elbow 90�
Connector
Aluminium elbow 90�
Connector
The aluminium 90° bend is used to change the direction of an aluminium ducting system by a 90° angle.
Aluminium elbow 90�
The aluminium 90° bend is used to change the direction of an aluminium ducting system by a 90° angle. Bends up to diameter 500 are sector bends.
The + products
- range compliant with gas CMEV requirements,
- suited to systems operating in saline atmospheres.
- available in diameters from 125 to 500,
- aluminium 1050A-H18 (formerly A5) compliant with DTU 68.3 for gas CMEV,
- M0 fire certification.
- easy assembly of interlocking accessories: ducts are female, accessories are male,
- Final seal requires sealant and/or perforated strip,
- attached to duct using self-tapping screws (4 to 6 depending on diameter).
| Insulation material |
|---|
| References | Ø (mm) |
|---|---|
| 11095302 - 90° BEND ALUMINIUM - D100 | |
| 11095303 - C 90° BEND aluminium - D125 | 125 |
| 11095305 - C 90° BEND aluminium - D160 | 160 |
| 11095306 - C 90° BEND aluminium - D200 | 200 |
| 11095307 - C 90° BEND aluminium - D250 | 250 |
| 11095308 - C 90° BEND aluminium - D315 | 315 |
| 11095309 - C 90° BEND aluminium - D355 | 355 |
| 11095310 - C 90° BEND aluminium - D400 | 400 |
| 11095311 - C 90° BEND aluminium - D450 | 450 |
| 11095312 - C 90° BEND aluminium - D500 | 500 |
| References | Fire protection rating |
|---|---|
| 11095302 - 90° BEND ALUMINIUM - D100 | |
| 11095303 - C 90° BEND aluminium - D125 | M0 |
| 11095305 - C 90° BEND aluminium - D160 | M0 |
| 11095306 - C 90° BEND aluminium - D200 | M0 |
| 11095307 - C 90° BEND aluminium - D250 | M0 |
| 11095308 - C 90° BEND aluminium - D315 | M0 |
| 11095309 - C 90° BEND aluminium - D355 | M0 |
| 11095310 - C 90° BEND aluminium - D400 | M0 |
| 11095311 - C 90° BEND aluminium - D450 | M0 |
| 11095312 - C 90° BEND aluminium - D500 | M0 |
