45° bend: 45° bend + seals Connector

45° bend: 45° bend + seals

Connector

The sealed 45° bend is used to change the direction of a galvanised ducting system by a 45° angle while delivering class C airtight performance.
45° bend: 45° bend + seals
See references
45° bend: 45° bend + seals
The sealed 45° bend is used to change the direction of a galvanised ducting system by a 45° angle while delivering class C airtight performance. The bends are pressed up to diameter 200, from 250 to 500 they use sectors.
45° bend: 45° bend + seals

The + products

  • easy and quick to install,
  • class C airtight performance,
  • aesthetic ducting.
  • available in diameters from 125 to 560,
  • galvanised steel as per EN 10346 ensuring uniformity of coating,
  • temperature range: - 30°C à + 100°C,
  • resistant to ageing (> 30 years), UV and ozone,
  • M0 fire certification,
  • class C airtight performance as per standard NF EN 12237.
  • to slot in or remove an accessory, rotate it slightly in the duct,
  • as an airtight seal is automatically provided by the ALDES seal, no need to use sealant or adhesive tape,
  • for vertical installations especially, the use of self-tapping screws remains recommended,
  • time savings in relation to ducting with standard accessories is in the range of 20 % (at least 15 to 30 seconds saved per junction for diameters 125 to 315, or at least 30 to 60 seconds saved for each accessory in these diameters),
  • ALDES sealed accessories are specially designed to ensure easy connection / disconnection. The ALDES range offers class C airtight performance and low connection torque.
45° bend: 45° bend + seals

Products and accessories references