30° bend
Connector
30° bend
Connector
The 30° bend is used to change the direction of a galvanised ducting system by a 30° angle.
30° bend
The 30° bend is used to change the direction of a galvanised ducting system by a 30° angle. Up to diameter 200 mm, bends are pressed; diameter 250 to 900 are sector bends.
- available in diameters from 80 to 900,
- galvanised steel as per EN 10346 ensuring uniformity of coating,
- M0 fire certification.
- easy assembly of interlocking accessories: ducts are female, accessories are male,
- Final seal requires sealant and/or perforated strip,
- attached to duct using self-tapping screws (4 to 6 depending on diameter).
| Insulation material |
|---|
| References | Ø (mm) |
|---|---|
| 11093096 - 30° PRESSED BEND GALVA - D80 | 80 |
| 11093097 - 30° PRESSED BEND GALVA - D100 | 100 |
| 11093099 - 30° PRESSED BEND GALVA - D160 | 160 |
| Fire protection rating |
|---|
| M0 |
