Aluminium elbow 45°
Connector
Aluminium elbow 45°
Connector
The aluminium 45° bend is used to change the direction of an aluminium ducting system by a 45° angle.
Aluminium elbow 45°
The aluminium 45° bend is used to change the direction of an aluminium ducting system by a 45° angle. Bends up to diameter 500 are sector bends.
The + products
- range compliant with gas CMEV requirements,
- suited to systems operating in saline atmospheres.
- available in diameters from 125 to 500,
- aluminium 1050A-H18 (formerly A5) compliant with DTU 68.3 for gas CMEV,
- M0 fire certification.
- easy assembly of interlocking accessories: ducts are female, accessories are male,
- Final seal requires sealant and/or perforated strip,
- attached to duct using self-tapping screws (4 to 6 depending on diameter).
